So it is time!
Yesterday I picked up the car from Arise Autobody, drove 2.5hrs to drop the car off with Ben from BENchmark ( follow him on instagram @benchmark.solutions ).
When I dropped off the car, I noticed that my good friend Mat Wootten had his Nissan R34 GTT in getting a few bits and pieces done. It has been many years since both of these cars have been in the same place!
We will be doing a lot to the evo while it's with benny, hopefully getting it started before WTAC as it would be great to show it off.
The car will be getting the fuel system done (surge tank setup), Motec PDM, Motec keypad, Motec M130 and a Motec E888 expander. Can't wait, and will keep you all updated!
So it’s been a while since I have updated here.
Will be releasing shirts and hoodies shortly.
Thanks for the support
Last week I moved the car to its next port of call on the road to completion… Can you guess where it is and what is happening?? 😉
Hey all! Welcome to 2016!!
I have been so busy with work I have neglected my status updates on the car!!
First of the updates is some new safety equipment. I will be pulling out my old roll cage and will be replacing it with a ‘national-spec’ roll cage. What this means is I really should start yoga just to try to get in and out of the car!!!
Thank you to Kazuhiro-San from Unlimited Works Japan for the gifts and stickers!
I can not wait to put the stickers on the car and I look forward to testing the parts you sent!
My wife was going through photos the other day.. and she came across a photo of the car last time it saw the track.
Massive change… What do you think?
Just a small update today. I have been recovering from world time attack challenge said I have not done much to the car.
With Xmas being so close, it is difficult to get into a fabricator but hoping to get into hypertune before Xmas to get things started.
I took a drive down to Arise Autobody to have a bit of a tinker with the car.